Type in http://192.168.1.1 and hit enter. If the page successfully loads, you will be shown with the screen in the image. Enter the Username and Password respectively and click Log In.
After logging in, you will be met with the Quick Start page. Enter the information below then click the Connect button and proceed to the next step.
User ID: username@streamyx
Password: your TMNet Streamyx password
Protocol: PPPoE
VPI: 0
VCI: 35
After clicking Connect, the screen will change and tell you that it is trying to connect with the settings you have specified. If everything works OK, you will be shown with the screen in the next step.
If the connection successfully established itself, you will be shown with this status page. Notice that the State column says Connected.
If the Connection State is connected, click the Save Settings link on the left side of the page. If the settings save successfully, it will notify you as in this image.
After saving your settings, click on the Reboot link from the menu on the left side of the page. After clicking the link, watch the modem’s status lights and wait for the PPP and DSL lights to go steady. Once it’s steady, you should be able to connect to the Internet.
Router Only Azteck WL830RT4
Login : 192.168.1.1
User Name : admin and password :admin
web Configuration
Aztech DSL600E Configuration
DSL600E From TMNET Configuration
Open Web browser type 192.168.1.1
Default Username = admin password = admin
Web Configutation Modem ADSL2
Aztech DSL605EW DSL605EU Configuration
Web Configuration For Aztech DSL605EW, Can Use DSL605EU Open browser Type 192.168.1.1
Default username and password = admin
Web Configuration simple fill username and password from ISP and Try to connect
Hardware Setup
A . Connect the pots splitter in to the telephone jack
B. Use a telephone cable
C. Use a Ethernet cable
D. 9Volt Power Adaptor Aztech DSL 600 EW Configuration
Aztech DSL 600 EW ADSL Wireless G Router Web Configuration
Open Your Browser ,Type Address http://192.168.1.1
U see below click begin
Fill Username & Password from ISP Fill VPI = 0 VCI = 35
Fill SSID anyware
Fill Your Country
Wireless Channel = default 6
This security 128 bit Encryption
Then u see Click Finish
click ok
Wait for Finish
Today, there have been 16 visitors (22 hits) on this page!
coptright sham (vads)....@ www.aku-dia.page.tl