This Quick Setup will guide you through the steps necessary to configure your ADSL router.
NOTE: All of original settings will be replaced by new settings after you finish these steps.
Select the check box below to scan the Internet connection automatically. It is recommended that there is no any PVC configured in your ADSL router before performing auto-scanning connection. Tick at Auto Scan Internet Connection (PVC).
Auto Scan Internet Connection
The scanning process will try to detect PPPoE or PPPoA connection provided by your ISP.
Example:
Scanning Internet connection...
PVC (0/35): detected as PPPoE LLC/SNAP
The ADSL router will configure 0/35 PPPoE LLC/SNAP as the Internet connection to your ISP.
Configure Internet Connection - WAN IP Settings
Enter information provided to you by your ISP to configure the WAN IP settings
Choose on the Obtain an IP address automatically because ur using dynamic IP
Tick on the Enable NAT
Configure Internet Connection - PPP User Name and Password
In order to establish the Internet connection, please enter PPP user name and password that your ISP has provided:
PPP User Name: username@streamyx
PPP Password: your TMNet Streamyx password
Note: Session established by; Choose Always On.
Configure LAN side Settings
Enter the ADSL router IP address and subnet mask for LAN interface and then enable DHCP server on LAN interface to provide IP address settings for your computers.
Primary IP Address: 192.168.1.1
Subnet Mask: 255.255.255.0
Quick Setup - Summary
Make sure that the settings below match the settings provided by your ISP.
Internet (WAN) Configuration: VPI / VCI 0 / 35
Connection Type: PPPoE LLC/SNAP
Always On
NAT Enabled
WAN IP Address Automatically Assigned
Default Gateway Automatically Assigned
DNS Server Automatically Assigned
LAN Configuration: Primary LAN IP 192.168.1.1 / 255.255.255.0
Secondary LAN IP: 0.0.0.0 / 0.0.0.0
DHCP Server Off
Note: Click Finish to accept these settings and reboot the system. Click Back to make any modifications
Walla! Now your ArtNet modem is in auto-connection mode.
Make sure your ADSL Router is properly connected prepare your computer network to connect to the ADSLOpen your WEB Browser and type 192.168.1.1
an enter username and password default is admin / 1234
Configure your Modem ADSL see below
Today, there have been 11 visitors (17 hits) on this page!
coptright sham (vads)....@ www.aku-dia.page.tl